22
English
Connections
NOTE
The surround speakers for HT-C5900 can also be connected to the Wireless Receiver Module
(SWA-5000) if you purchase it separately.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver
module is too close to the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card or any other device that uses
the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due
to interference.
The transmission distance from the product to the wireless receiver module is about 10m, but
may vary depending on your operating environment. If a steel-concrete wall or metallic wall is
between the product and the wireless receiver module, the system may not operate at all,
because the radio wave cannot penetrate metal.
If the product doesn't make wireless connection, the system needs ID Setting between the
product and wireless receiver module. With the product turned off, press the remote control's
number buttons "0"
"1"
"3"
"5" and turn on the product. With the wireless receiver module
turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds.
✎
CAUTION
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output
from the surround speaker connectors on the product.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If no sound is heard from the wireless surround speakers, switch the mode to DVD 5.1 channel or
Dolby Pro Logic
II
.
In 2-CH mode, no sound will be heard from the wireless surround speakers.
!
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into
the red (+) terminal, and then release the tab.
Connect the connecting plugs to the back of the product by
matching the colours of the speaker plugs to the speaker jacks.
With the product turned off, insert the TX card into the TX Card
Connection(WIRELESS) on the back of the product.
Hold the TX card so that the label "WIRELESS" faces upward and
insert the card into the port.
The TX card enables communication between the product and
the wireless receiver module.
Connect the left and right surround speakers to the wireless
receiver module.
Plug the power cord of the wireless receiver module in the
wall outlet.
Turn on the product. The product and wireless receiver
module will now communicate with each other and you
1.
2.
3.
4.
•
•
5.
6.
7.
Black
Red
WIRELESS
TX card
HT-C5900_5950W_XSA_0504.indd 22
HT-C5900_5950W_XSA_0504.indd 22
2010-05-04 11:10:28
2010-05-04 11:10:28
Содержание HT-C5900
Страница 71: ...Code No AH68 02298N ...
