English - 19
I
N S TA L L AT I O N
Connecting a Second VCR to Record from the TV
Your TV can send out signals of its picture and sound to be recorded by a second VCR. To do
this, connect your second VCR as follows:
1
Connect a set of audio cables between the
“AV OUT (L, R)” jacks on the TV and the AUDIO
IN jacks on the VCR.
(The VCR input jacks might be either on the
front or rear of the VCR.)
2
Connect a video cable between the “AV OUT
(VIDEO)” jack on the TV and the VIDEO IN jack
on the VCR.
Refer to your VCR’s instructions for more
information about how to record using this
kind of connection.
Connecting a Camcorder
The side panel jacks on your TV make it easy to connect a camcorder to your TV. They allow
you to view the camcorder tapes without using a VCR. (Also see “Viewing an External Signal
Source” on page 47.)
1
Locate the A/V output jacks on the camcorder. They are
usually found on the side or rear of the camcorder.
2
Connect a set of audio cables between the “AV 3 (L, R)”
jacks on the TV and the AUDIO OUT jacks on the camcorder.
If you have mono camcorder, connect L(mono) to
camcorder audio out using only one audio cable.
3
Connect a video cable between the “AV 3 (VIDEO)” (or
“S-VIDEO”) jack on the TV and the VIDEO OUT jacks on the
camcorder.
The audio-video cables shown here are usually included
with a Camcorder. (If not, check your local electronics
store.) If your camcorder is stereo, you need to connect a
set of two cables.
• This figure shows the Standard connector-jack panel. The actual configuration for your TV may be
different.
TV Side Panel
(HC-R4245W)
S-Video Cable
Video Cable
Audio Cable
or
Camcoder
TV Rear Panel
From Cable
Coaxial Cable
Video Cable
Audio Cable
VCR Rear Panel
From Antenna
1
2
1
2
3
BP68-00334B-01Eng 2005/05/06 12:29 PM Page 19
