24
Heating & Hot Water Installation
Cylinder Timer, if you are heating a hot water cylinder
To avoid the cylinder heating being switched off accidentally we normally add 2 on timers a day, one
at 3-00 am and one at 15-00 pm. This stops nuisance tripping, resets the unit after power cuts and
insures the cylinder is hot 24 hours a day. We don’t normally set any off times.
To set the cylinder up as above:
1.
Press
Timer
button once,
2.
Press
right
, daily is flashing, daily is the hot water time clock, press right
3.
Press
right
1 will show,
4.
Press
right
,
5.
On systems with a 12-hour clock, pm shows, press
up
till am and pm shows (24hours).
6.
Press
right
, hours will be flashing, use
up
to set hours to 0300.
7.
Press
right
, minutes will be flashing.
8.
Press
right
, ON will be flashing.
*
9.
Press
right
, the tap will appear,
10.
Press
Set
You will return to 2 above. Now repeat with a timer at 15-00 hours.
You can delete or adjust timers by entering timer mode, press
Timer
once and scrolling
up and
down
to the timer you want to adjust, just keep scrolling
right
to the part you want to change and
then use
up down
to adjust it, then press
Set
to store. To delete a timer select it with
up and down
and press
Delete
, to save the changes made press the
Set
button.
When you are finished press
ESC
.
Systems with Solar cylinder heating
With solar systems its best to switch off the cylinder heating during the day to give the solar the best
chance of heating the cylinder for free.
*If you want to set an
off timer
at step 8 above, press up to change on to off.
Installation Manual.indd 24
31/08/2018 19:01:34
