Samsung Freedom MIM-E03AN, Руководство по установке и обслуживанию

Страница: 17 / 36

17
Heating & Hot Water, Pre-Plumbed Installation
Setting the Clock and Backlight
1. Press User Set once 1 shows on the screen.
2. Press up until 2 shows,
3. Press right twice, Year will show, use up to change year, press Set , 22 appears,
4. Press
right
Month will be flashing, adjust Month with
up
,
5. Press
right
, day will be flashing, adjust day with
up
,
6. Press
Set
. 22 shows, press
up
once, 23 shows,
7. Press
right
, day and time are shown, day will be flashing, use
up
to adjust day,
8. Press
right
, AM or PM will be flashing, use
up
to adjust AM, PM or both (24-hour clock),
9. Press
right
, hour will flash, press
up
to adjust hours,
10. Press
right
, minutes will flash, use
up
to adjust minutes,
11. Press
Set
.
12. 23 shows, Press
left
2 flashes, press
up
twice 4 flashes,
13. Press
right
, 4 0511 shows, 05 flashes. This is the backlight time,
14. Press
up
until 30 flashes,
15. Press
Set
, it will now stay on for 30 seconds,
16. Press
ESC
to finish and return to normal screen.
Cylinder Timer
To avoid the cylinder heating being switched off accidentally we normally add 2 on timers a day, one at 3:00 am and one at 15:00 pm.
This stops nuisance tripping, resets the unit after power cuts and insures the cylinder is hot 24 hours a day. We don’t normally set any off
times.
To set the cylinder up as above:
1. Press
Timer
button once,
2. Press
right
, daily is flashing, daily is the hot water time clock, press
right
3. Press
right
1 will show,
4. Press
right
,
5. On systems with a 12-hour clock, pm shows, press
up
till am and pm shows (24hours).
6. Press
right
, hours will be flashing, use
up
to set hours to 0300.
7. Press
right
, minutes will be flashing.
8. Press
right
, ON will be flashing. *
9. Press
right
, the tap will appear,
10. Press
Set
You will return to 2 above. Now repeat with a timer at 15-00 hours.
You can delete or adjust timers by entering timer mode, press Timer once and scrolling up and down to the timer you want to adjust,
just keep scrolling right to the part you want to change and then use up down to adjust it, then press Set to store. To delete a timer
select it with up and down and press Delete , to save the changes made press the Set button. When you are finished press ESC.
Don’t worry about the field settings, we have already had these done for you for use with your setup.
Installation Manual.indd 17 31/08/2018 19:01:25