Installation
Installation
English
10
If this is a new installation, follow these steps:
1.
Using a 2
1
/
2
inch hole saw, cut a hole into the side of the cabinet that holds the sink as
shown in
Figure 1-1
below.
2.
If the base inside the sink cabinet is raised above the kitchen floor and is higher than the
connections on the dishwasher, make a hole in the base inside the cabinet and in the cabinet
side as shown in
Figure 1-2
.
NOTE
Depending on where your electrical outlet is, you may need to cut a hole in the opposite
cabinet side.
Figure 1-1
The hole for the water supply line, drain
hose and power cables.
Figure 1-2
CAUTION
Make sure the cabinet hole is smoothened before you insert the drain hose through the
hole. A sharp edge of the cabinet hole may cause damage to the drain hose, resulting in a
leak of the hose.
DW9900R_DD68-00208B-00_EN.indd 10
12/29/2018 1:57:41 PM
