Disassembly and Reassembly _ 9
3. DISASSEMBLY AND REASSEMBLY
3-1. TOOLS FOR REMOVAL AND REASSEMBLY
Tool image
No.
Tool
Type
Remarks
➊
Adjustable Wrench
➋
Open-end Wrench
1-7/16”
Leg
➌
Vice pliers
➍
Others
(screwdriver, nipper, long nose pliers)
Common tools for servicing
Screwdriver - Philips, flat, Torx T20, Small flat
➎
Nut Driver
10mm
Heater bracket Nut
* Preparation for parts replacement
1. Take out the residual water inside the product.
(Drain the water by operating the drain pump)
2. Close the water supply valve.
3. Turn off the power & disconnect power cable.
You must turn off the circuit breaker connected to the product.
4. Pull out the unit from the sink and lay it on the floor.
Be careful of the drain hose when pulling out the unit.
WARNING
Always turn off the electric power supply & water supply before servicing any electrical component,
making ohmmeter checks, or replacing any parts.
CAUTION
Before moving the unit, laying it down for service, or removing any parts for service be sure to drain as
much of the water from the unit as possible.
Use a protective mat or towel to prevent damage to the floor or having any of the remaining water spill on the floor.
NOTE
All voltage checks should be made with a voltmeter having a full scale range of 250 volts or higher.
After service is completed, be sure all safety grounding circuits are complete, all electrical connections are secure,
and all access panels are in place.
※
Before servicing, make sure to remove all items include baskets inside dishwasher
.
