English
62
Oper
ations
Operations
Salt storage
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance. The higher the
content of these minerals and salts, the harder your water is. The softener should be
adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
1.
Turn the dishwasher on.
2.
Press and hold the
AUTO
cycle button for five seconds within 60 seconds from turning
on the dishwasher.
- When you entered the Setting mode, the display will show “0:00”.
3.
Press the
Delay Start
button to select the water hardness level setting menu.
- The display shows the current setting. (Default setting: “H3”)
4.
Press the
AUTO
cycle button to change the setting.
- You can select from H1 – H6 (soft – hard).
5.
Wait 5 seconds to save the setting.
NOTE
• It is recommended that adjustments should be made in accordance with the following
(or Manual) table.
• Default Setting: H3
DW8500AM_DW60A8070BB_EF_DD81-03206D-01_PL+EN.indb 62
DW8500AM_DW60A8070BB_EF_DD81-03206D-01_PL+EN.indb 62
2021-03-24 �� 1:01:13
2021-03-24 �� 1:01:13
