26
EN
Cleaning Your Smart Oven
The following parts of your Smart Oven should be cleaned regularly to
prevent grease and food particles from building up:
•
Inside and outside surfaces
•
Door and door seals
•
Turntable and Roller rings
☛
ALWAYS
ensure that the door seals are clean and the door closes
properly.
☛
Failure to maintain the oven in a clean condition could lead to
deterioration of the surface that could adversely affect the of the appliance
and possibly result in a hazardous situation.
1.
Clean the outside surfaces with a soft cloth and warm, soapy water. Rinse and
dry.
2.
Remove any splashes or stains on the inside surfaces or on the roller ring with a
soapy cloth. Rinse and dry.
3.
To loosen hardened food particles and remove smells, place a cup of diluted
lemon juice on the turntable and heat for ten minutes at maximum power.
4.
Wash the dishwasher-safe plate whenever necessary.
✉
DO NOT
spill water in the vents.
NEVER
use any abrasive products
or chemical solvents. Take particular care when cleaning the door
seals to ensure that no particles:
•
Accumulate
•
Prevent the door from closing correctly
✉
Clean the Smart Oven cavity right ofter each use with a mild detergent
solution, but let the Smart Oven cool down before cleaning in order to
avoid injury.
✉
The instructions for cooking ranges, hobs and ovens shall state that a
steam cleaner is not to be used.
Installation & Wiring Instructions
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse.
The value of the fuse is indicated on the pin face of the plug and, if it requires replacing,
a fuse approved to BS1363 of the same rating must be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a
replacement fuse cover is required, it must be of the same colour as the pin face of the
plug.
✉
Replacement covers are available from your Dealer. If the fitted plug
is not suitable for the power points in your house or the cable is not
long enough to reach a power point, you should obtain a suitable
safety approved extension lead or consult your Dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the
fuse and then safely dispose of the plug. Do not connect the plug to a
mains socket, as there is a risk of shock hazard from the bared flexible
cord.
ijlXX`\l|TWZX]ZhUGGwGY]GG{ SGkGY^SGYWW\GGXa\XGwt
