Samsung AR-KP/JP Series, Руководство пользователя и инструкция по установке

Страница: 38 / 52

10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
• In Russia and Europe, consult with the supply authority to determine the supply system impedance before
installation.
• Connect the wires firmly so that wires can not be pulled out easily.
(If they are loose, it could cause burn-out of the wires.)
• Connect the wires according to color codes, referring to the wiring diagram.
• The power cable and the interconnection cable should be selected according to the specification in page 36.
Power Wiring and Communication Wiring Configuration
• Be sure to run the power supply cable and the communication cable through electrical conduit as seen in the picture.
• Install the communication cable, indoor power cable and the main power cable in the cable tube.
• Secure the cable tube to the outdoor knockout using the CD connector and bushing.
• Arrange the cables as shown in the picture.
• The diameter of the 6 knock-out holes is Ø27.8 mm(Ø1-3/32 inch).
Communication cable
Main power cable
(Inside)
(Outside)
• Make a knockout hole by driving in a nail.
• When installing the cables through the knockout hole, remove all burrs and protect them with the protection tape.
• Apply rust resisting paint around the hole.
• Also circular terminal must be matched with screw size in terminal block.
• After connecting the cables, make sure terminal numbers on the indoor/outdoor unit matches.
• Please ensure that Power & Communication cables are separated, they must not be in the same cable.
• Power & Communication cable shall not exceed 30m.
Indoor unit
Outdoor unit
Indoor unit
Outdoor unit
Ground wire
(Green/Yellow)

Ground wire
(Green/Yellow)

N 1 L 1 1 2 3 4 N L
N 1 L 1 1 2 3 4
1
L1 N1
1
L1 N1
N L
Circuit Breaker
(main power)
English-38