26
Deciding on where to install the product
Selecting appropriate location for installation
Decide the installation location based on the following condition and obtain the user’s approval.
X
f
Avoid a place that may disturb your neighbor. Noise may occur from the outdoor unit and the discharged air may run into
the neighborhood. (Be careful of the operation time in a residential area)
X
f
Install the outdoor unit on a hard and even area that can support its weight.
X
f
Choose a flat place that rainwater does not settle or leak.
X
f
Choose a place avoiding strong winds.
X
f
Maintain sufficient space for repairs and service.
X
f
Choose a place where you can easily connect the pipes and cables to the indoor unit.
X
f
Make sure that the condensed water dripping from the drain hose runs out properly and safely.
X
f
When installing the outdoor unit near seashore, make sure it is not directly exposed to sea breeze. If you can not find a
adequate place without direct sea breeze, protection wall should be constructed.
X
f
Install the outdoor unit in a place (such as near buildings etc.) where it can be prevented from sea breeze which can
damage the outdoor unit.
Outdoor unit
Sea breeze
Sea
Outdoor unit
Sea breeze
Sea
X
f
If you cannot avoid installing the outdoor unit by the seashore, construct a protection wall around to block the sea
breeze.
Protection wall
Outdoor unit
Sea breeze
Sea
• Protection wall should be constructed with a solid material such as
concrete to block the sea breeze and the height and the width of the
wall should be 1.5 times larger than the size of the outdoor unit. Also,
secure over 700mm between the protection wall and the outdoor unit
for exhausted air to ventilate.
X
f
Install the outdoor unit in a place where water can drain smoothly.
❋
If you cannot find a place satisfying above conditions, please contact manufacturer. Make sure to clean the sea water
and the dust on the outdoor unit heat exchanger and spread corrosion inhibitor on heat exchanger. (At least one time
per one year.)
X
f
Choose a place where there is no direct sunlight.
X
f
Choose a place where it could not come into contact with snow and rain.
X
f
Choose a place where flammable gas does not leak.
X
f
Choose a place where the indoor and outdoor unit can be connected with a pipe.
X
f
Choose a place where there is no direct sunlight.
X
f
Choose a place where it could not come into contact with snow and rain.
X
f
Choose a place where flammable gas does not leak.
X
f
Choose a place where the indoor and outdoor unit can be connected with a pipe.
PAC_아프리카 중동향AP80S0A_IBIM_34514A-02_EN.indd 26
2015-04-23 오후 2:18:56
