Samsung AM JXVHGH EU Series, Технический справочник

Страница: 107 / 111

※ When installing outdoor units in modul e , sele c t the po w er supply cable a cc ording to the sum of outdoor unit
capacity . (Refer to the table for each model)
※ P o w er Supply c ords of parts of applian c es for outdoor use shall not be lig h ter than polychloroprene sheathed
fl e xible c or d. ( C ode desig n ation IEC:60245 IEC 66 / CENELEC: H07RN-F)
Ex . ) A M500* XVA
A M120* XVA : 4 mm 2
A M280* XVA : 16 mm 2
A M500* XVA : 35 mm
2
①
②
③
A M220* XVA A M160* XVA A M120* XVA
② ③ ①
EL CB
MC CB+ELB
or
• This device is intended for the connection to a power supply system with a maximum permissible system
impedance shown in the table (on the left page) at the interface point (power service box) of the user’s
supply .
• The user must ensure that this device is connected only to a power supply system which fulfills the
requirement above . If necessary, the user can ask the public power supply company for the system
impedance at the interface point .
• This equipment complies with IEC 61000-3-12 provided that the short-circuit power Ssc is greater than
or equal to Ssc(*2) at the interface point between the user’s supply and the public system . It is the
responsibility of the installer or user of the equipment to ensure, by consultation with the distribution
network operator if necessary, that the equipment is connected only to a supply with a short-circuit power
Ssc greater than or equal to Ssc(*2) .
[Ssc (*2)]
Model Ssc [MVA] Model Ssc [MVA]
AM080JXVHG ✴ 3 .3 AM180JXVHG ✴ 7 .6
AM100JXVHG
✴
4 .5 AM200JXVHG
✴
8 .1
AM120JXVHG
✴
5 .3 AM220JXVHG
✴
8 .6
AM140JXVHG ✴ 5 .3 AM240HXVAG ✴ 11 .7
AM160JXVHG
✴
6 .8 AM260HXVAG
✴
8 .6
Model Ssc [MVA] Model Ssc [MVA]
AM080JXVAG
✴
3 .3 AM160JXVAG
✴
6 .8
AM100JXVAG
✴
4 .5 AM180JXVAG
✴
7 .6
AM120JXVAG
✴
5 .3 AM200JXVAG
✴
8 .1
AM140JXVAG ✴ 5 .3 AM220JXVAG ✴ 8 .6
NOTE
Caution for electrical work
• You must install ELCB or MCCB + ELB
- ELCB: Earth leakage breaker
- MCCB: Molded case circuit breaker
- ELB: Earth leakage breaker
• Do not operate the outdoor unit before completing the refrigerant pipe work .
• Do not disconnect or change the cable inside the product . It may cause damage to the product .
• Specification of the power cable is selected based on following installation condition; culvert installation/
ambient temperature 30 °C/ single multi conductor cables . If the condition is different from the ones
stated, please consult an electrical installation expert and re-select the power cable .
- If the length of power cable exceed 50m, re-select the power cable considering the voltage drop .
• Use a power cable made out of incombustible material for the insulator (inner cover) and the sheath (outer
cover) .
• Do not use the power cable with the core wire exposed due to insulator damage occurred during removal
of the sheath . When the core wire is exposed, it may cause fire .
Insulator (inner cover) Exposed wire
core
<The example of exposed core wire>
Sheath (outer cover)
CAUTION
Installation
9
107