Samsung AM***FNHDCH, Руководство по установке, Страница: 29 / 38

28
Setting an indoor unit address and installation option
Setting an indoor unit installation option (suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional
power supply in the indoor unit.
2. The panel(display) should be connected to an indoor unit to receive
option.
3. Set the installation option according to the installation condition of an
air conditioner.
- The default setting of an indoor unit installation option is “020010-
100000- 200000-300000”.
- Individual control of a remote controller(SEG20) is the function that
controls an indoor unit individually when there is more than one
indoor unit.
4. Set the indoor unit option by wireless remote controller.
Indoor Unit
1(L)
F2
F1
2(N)
■
02 series installation option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 1 -
External room
temperature sensor
Central control
FAN RPM
compensation
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Drain pump Hot water heater -
EEV Step when
heating stops
Master / Slave
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 External control
External control
output
S-Plasma ion Buzzer
Number of hours
using filter
SEG19 SEG20 SE21 SEG22 SEG23 SEG24
3
Individual control of
a remote controller
Heating setting
compensation
EEV Step of stopped
unit during oil
return/defrost mode
Motion detect
sensor
-
f
1WAY/2WAY/4WAY MODEL : Drain pump(SEG8) will be set to ‘USE + 3minute delay’ even if the drain pump is set to 0.
f
1WAY/2WAY/4WAY, DUCT MODEL : Number of hours using filter(SEG18) will be set to ‘1000hour’ even if the SEG18 is set
to exept for 2 or 6.
f
When setting the option other than above SEG values, the option will be set as “0”.
f
SEG5 central control option is basically set as 1(Use), so you don’t need to set the central control option additionally.
However, if the central control is not connected but it doesn’t indicate an error message, you need to set the central
control option as 0 (Disuse) to exclude the indoor unit from the central control.
⴬㨰䛙GiŽGkœŠ›†pt†lu†WZ_W^hOXPU•‹‹GGGY_ YWXZTWZTW]GGG㝘㤸GXWaW\aX`