Samsung AM FN1DEH Series, Руководство по установке, Страница: 35 / 50

35
ENGLISH
02 series installation option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2 Evaporator Drying
Use of external
room temperature
sensor / Minimizing
fan operation when
thermostat is off
Use of central
control
FAN RPM
compensation
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Use of drain pump
Use of hot water
heater
-
EEV Step when
heating stops
-
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
Use of external
control
Setting the output
of external control
/ External heater
signal / Cooling
operation signal /
Free Cooling control
signal
S-Plasma ion Buzzer control Hours of filter usage
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Individual control of
a remote controller
Heating setting
compensation
/ Removing
condensate water in
heating mode
Adjusted EEV step
of stopped unit
during oil return /
defrost mode.
Motion detect sensor -
• 1WAY / 2WAY / 4WAY MODEL: Drain pump(SEG8) will be set to ‘USE + 3minute delay’ even if the drain pump is set to 0.
• 1 WAY / 2WAY / 4WAY, DUCT MODEL : Number of hours using filter(SEG18) will be set to ‘1000hour’ even if the
SEG18 is set to exept for 2 or 6.
• When setting the option other than above SEG values, the option will be set as “0”.
• SEG5 central control option is basically set as 1 (Use), so you don’t need to set the central control option
additionally. However, if the central control is not connected but it doesn’t indicate an error message, you need to
set the central control option as 0 (Disuse) to exclude the indoor unit from the central control.
• The output of hot water heater in SEG9 is generated from the hot coil part of the terminal board in duct models.
F4 F3
F1 F2
V2 V1 1(L) 2(N)
2
1
HOT
COIL
AC
POWER
OUTDOOR
COMMUNICATION Wire Remote
Controller
DC 12 V
* The output of hot coil terminal is AC 220 V / 230 V
(The same as Indoor Unit’s input Power)
COM1 COM2 (+) L N (-)
• The external output of SEG15 is generated by MIM-B14 connection. (Refer to the manual of MIM-B14.)