Samsung AE022MNJDEH, Руководство по установке

Страница: 6 / 34

6
Installation Procedure
Ins
tallation Pr
oc
edur
e
English
Step 2 Choosing the installation
location
General requirements for installation location
Do not install the air conditioner in a location where it
will come into contact with the following elements:
• Combustible gases
• Saline air
• Machine oil
• Sulphide gas
• Special environmental conditions
Avoid installing the air conditioner in a location with the
following conditions:
• In areas where it is exposed to direct sunlight. Close
to heat sources.
• In damp areas or locations where it could come into
contact with water. (for example rooms used for
laundry)
• In areas where curtains and furniture could affect the
supply and discharge of air.
• Without leaving the required minimum space around
the unit. (as shown in the drawing)
• In scarcely ventilated areas.
• On surfaces that are unable to support the weight
of the unit without deforming, breaking or causing
vibrations during the use of the air conditioner.
• In a position that does not enable the condensate
drainage pipe to be correctly installed. (at the end
of the installation. It is always essential to check the
efficiency of the drainage system)
Indoor unit installation requirement
• This unit has to be installed as floor type only.
• There must be no obstacles near the air inlet and
outlet.
• Select a convenient location that permits the air to
reach every corner of the area to be cooled.
• Pre-plan for easy and short routing of the refrigerant
tubing and wiring to the outdoor unit.
• There should be no flammable gas, alkaline,
substances present in the air.
• Maintain sufficient clearance around the indoor unit.
• Make sure that the water dripping from the drain
hose runs away correctly and safely.
• Do not install the unit where it will be exposed to
direct sunlight.
CAUTION
• Our units should be installed in compliance with the
spaces shown in the installation manual, to ensure
accessibility from both sides and allow repairs
or maintenance operations to be carried out. The
unit’s components should be accessible and easy to
disassemble without endangering people and objects.
• For this reason, when provisions of the installation
manual are not complied with, the cost required to
access and repair the units (in SAFETY CONDITIONS,
as set out in prevailing regulations) with harnesses,
ladders, scaffolding or any other elevation system
will NOT be considered part of the warranty and will
be charged to the end customer.
A
A
A : 300mm or more
B : 1000mm or more
B