Samson TROVIS 6616-1, Монтаж и эксплуатация

Страница: 19 / 96

EB 6616-1/-2 EN 5-1
Installation
5 Installation
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
5.1 Installation conditions
Work position
The work position for the web terminal is the
front view onto the display of the web termi-
nal seen from the position of operating per-
sonnel.
Operators must ensure that, after installation
of the web terminal, the operating personnel
can perform all necessary work safely and
easily access the web terminal from the work
position.
5.2 Preparation for installation
Before mounting, make sure the following
conditions are met:
− The web terminal is not damaged.
Proceed as follows:
Î
Lay out the necessary material and tools
to have them ready during mounting.
5.3 Mounting the web terminal
Risk of damaging the touch screen.
Î
Do not be place the web terminal front
side down on hard surfaces.
NOTICE
!
The installation requires a panel cut-out. The
wall thickness of the panel must not exceed
3 mm.
5.3.1 TROVIS 6616-1
Panel mounting
1. Make the panel cut-out (see Fig. 5-1).
2. Drill four holes (see Fig. 5-1).
3. Push the web terminal into the panel cut-
out from the front.
4. Fasten the web terminal to the panel
from the back with the four supplied
screws.
VESA mount
Optionally, the VESA mount at the back of
the TROVIS 6616-1 Web Terminal can be
used for mounting. The fastening screws
must not be screwed into the thread further
than 9 mm.
5.3.2 TROVIS 6616-2
Panel mounting
1. Make the panel cut-out (see Fig. 5-2).
2. Push the web terminal into the panel cut-
out from the front.
3. Clamp the web terminal from the back
against the control panel using the sup-
plied clips.