Samson KA 5500-Z EN, Быстрое руководство

Страница: 7 / 20

KA 5500-Z EN 7
Installation
4.1 Installation
Dimensions in mm (W x H x D): 144 x 98 x 54
The controller consists of the electronics housing and the back panel with the terminals. The
device is suitable for panel, wall and rail mounting (see Fig. 2).
Panel mounting
1. Undo the two screws (1).
2. Pull apart the electronics housing and the back panel.
3.
Make panel cut-out with the dimensions 138 x 92 mm (W x H).
4. Push the housing through the panel cut-out.
5. Tighten the two screws (2) to clamp the controller housing against the panel.
6. Perform electric wiring on the back panel as described in section 4.2.
7. Place on the electronics housing.
8. Tighten the two screws (1).
Wall mounting
1. Undo the two screws (1).
2. Pull apart the electronics housing and the back panel.
3.
If necessary, drill holes with the specified dimensions in the appropriate places. Fasten
the back panel with four screws.
4. Perform electric wiring on the back panel as described in section 4.2.
5. Place on the electronics housing.
6. Tighten the two screws (1).