Samson KA 5500-Z EN, Быстрое руководство

Страница: 10 / 20

10 KA 5500-Z EN
Installation
4.2 Electrical connection
Risk of fatal injury due to electric shock.
− For electrical installation, you are required to observe the relevant electrotechnical regula-
tions of the country of use as well as the regulations of the local power suppliers. Therefore,
such work must be performed by trained and experienced personnel.
− The terminal 28 allows the integration of safety equipment which have a direct influence on
electric actuators. If this is not the case, connect a jumper from terminal 20 to terminal 28.
Î
Do not connect ELV cables (according to VDE 0100) to these terminals.
Î
Disconnect the voltage supply from the controller and protect it against unintentional re-
connection before performing any work on the terminals.
The electric actuators and pumps are not automatically supplied with a voltage by the TRO-
VIS I/O module. They can be connected over terminals 24 and 28 to an external voltage
supply. If this is not the case, connect a jumper from terminal 20 to terminals 24 and 28.
A wiring diagram is affixed to the back of the electronics housing. It shows the assignment of
the terminals on the back panel.
DANGER !
Note