Samson EB 8111 EN, Монтаж и эксплуатация

Страница: 41 / 72

EB 8111/8112 EN 9-3
Servicing
Risk of valve damage due to the use of
unsuitable tools.
Î
Only use tools approved by SAMSON
(
u
AB 0100).
Risk of valve damage due to the use of
unsuitable lubricants.
Î
Only use lubricants approved by
SAMSON (
u
AB 0100).
The control valve was checked by SAMSON
before it left the factory.
− Certain test results certified by SAMSON
lose their validity when the valve is
opened. Such testing includes seat leakage
and leak tests.
− The product warranty becomes void if ser-
vice or repair work not described in these
instructions is performed without prior
agreement by SAMSON's after-sales ser-
vice.
− Only use original spare parts by
SAMSON, which comply with the original
specifications.
9.1 Periodic testing
Depending on the operating conditions,
check the valve at certain intervals to prevent
a possible failure before it can occur. Opera-
tors are responsible for drawing up an in-
spection and test plan.
Our after-sales service can support you in
drawing up an inspection and test plan for
your plant.
NOTICE !
NOTICE !
Note
Tip
We recommend the following inspection and testing which can be performed while the pro-
cess is running:
Inspection and testing Action to be taken in the event of a negative result:
Check the markings, labels and name -
plates on the valve for their readability
and completeness.
Immediately renew damaged, missing or incorrect name-
plates or labels.
Clean any inscriptions that are covered with dirt and are
illegible.
Check the pipe connections and gaskets
on the valve and actuator for leakage.
Check the bolted joint (tightening torque).
Replace the gasket on the flanged joint as described in sec
-
tion 9.4.1.
Replace the packing. See section 9.4.2.