Samson 43-8, Монтаж и эксплуатация

Страница: 4 / 32

4 EB 2178 EN
Safety instructions and measures
1 Safety instructions and measures
Intended use
The Type 2438 Hydraulic Controller with Type 2432 Valve and Type 2430 Control
Thermostat is designed for temperature control of the energy supply to heat generators (e.g.
heat exchangers) by closing the valve. The regulator is mainly used to control the temperature
in instantaneous water heaters in small district heating units.
The devices are designed to operate under exactly defined conditions (e.g. operating
pressure, process medium, temperature). Therefore, operators must ensure that the devices
are only used in operating conditions that meet the specifications used for sizing the devices
at the ordering stage. In case operators intend to use the devices in applications or
conditions other than those specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the de-
vice for its intended purpose or for damage caused by external forces or any other external
factors.
Î
Refer to the technical data and nameplate for limits and fields of application as well as
possible uses.
Reasonably foreseeable misuse
The devices are not suitable for use outside the limits defined during configuration and by the
technical data. Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described
Qualifications of operating personnel
The devices must be mounted, started up, serviced and repaired by fully trained and
qualified personnel only; the accepted industry codes and practices are to be observed.
According to these mounting and operating instructions, trained personnel refers to
individuals who are able to judge the work they are assigned to and recognize possible
hazards due to their specialized training, their knowledge and experience as well as their
knowledge of the applicable standards.