Samson 43-6, Монтаж и эксплуатация

Страница: 33 / 68

EB 2172 EN 5-5
Installation
5.3 Mounting
The components (valve, control thermostat
and, if applicable, thermowell) of the regula-
tor are delivered separately. The activities
listed below are necessary for installation
and before start-up of the regulator.
Risk of regulator damage due to exces -
sively high or low tightening torques.
Observe the specified torques when tighten -
ing regulator components. Excessive tighten-
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Î
Observe the specified tightening torques
(see 'Tightening torques' in Annex).
NOTICE !
Risk of regulator damage due to the use of
unsuitable tools.
Î
Only use tools approved by SAMSON
(see 'Tools' in Annex).
Risk of regulator damage due to the use of
unsuitable lubricants.
Î
Only use lubricants approved by
SAMSON (see 'Lubricants' in Annex).
NOTICE
!
NOTICE
!
1 6 2 3
5 4
1 Shut-off valve
2 Strainer
3 Temperature regulator
4 Thermometer
5 Temperature sensor
6 Shut-off valve
Fig. 5-2: Installation example · Type 43-6 in a cooler