Samson 3595, Монтаж и эксплуатация

Страница: 7 / 76

EB 8079 EN 1-3
Safety instructions and measures
Hazards resulting from the special working conditions at the installation site of the valve must
be identified in a risk assessment and prevented through the corresponding safety instruc-
tions drawn up by the operator.
Responsibilities of the operator
The operator is responsible for proper operation and compliance with the safety regulations.
Operators are obliged to provide these mounting and operating instructions as well as the
referenced documents to the operating personnel and to instruct them in proper operation.
Furthermore, the operator must ensure that operating personnel or third persons are not ex-
posed to any danger.
Responsibilities of operating personnel
Operating personnel must read and understand these mounting and operating instructions as
well as the referenced documents and observe the specified hazard statements, warnings
and caution notes. Furthermore, the operating personnel must be familiar with the applicable
health, safety and accident prevention regulations and comply with them.
Referenced standards and regulations
The control valves comply with the requirements of the European Pressure Equipment Direc-
tive 2014/68/EU. Valves with a CE marking have a declaration of conformity, which in-
cludes information about the applied conformity assessment procedure. The 'Certificates' sec-
tion contains this declaration of conformity.
Non-electric valve versions whose bodies are not lined with an insulating material coating do
not have their own potential ignition source according to the risk assessment stipulated in
EN 13463-1:2009, section 5.2, even in the rare incident of an operating fault. Therefore,
such valve versions do not fall within the scope of Directive 2014/34/EU.
Î
For connection to the equipotential bonding system, observe the requirements specified in
section 6.4 of EN 60079-14 (VDE 0165-1).
Referenced documentation
The following documents apply in addition to these mounting and operating instructions:
− Mounting and operating instructions for mounted actuator, e.g.
u
EB 8318 for
Type 3276 Actuator or
u
EB 8310-X for Type 3271 Actuator
− Mounting and operating instructions for mounted valve accessories (positioner, solenoid
valve etc.)
− For oxygen service
1)
: Manual
u
H 01
1)
See information on order-specific installation drawing