SamplexPower MSK-20A, Руководство пользователя

Страница: 4 / 28

4 | SAMLEX AMERICA INC.
SECTION 1 | Safety Instructions
13. Batteries generate Hydrogen and Oxygen during charging resulting in evolution of explosive
gas mixture in non-sealed batteries. Care should be taken to ventilate the battery area
when non-sealed batteries are used and follow battery manufacturer’s recommendations.
14. Ensure there are no flammable substances, explosive gases, flames, smoke or spark near
the battery or the Solar Panel(s).
15. Use caution to reduce the risk of dropping a metal tool on the battery. It could spark or
short circuit the battery or other electrical parts and could cause an
explosion.
16. Remove metal items like rings, bracelets and watches when working with batteries. Batter-
ies can produce a short circuit current high enough to weld a ring or the like to metal and
thus, cause a severe burn.
17. If you need to remove a battery, always remove the Negative (Ground) connection from the
battery first. Make sure that all the accessories are off so that you do not cause a spark.
18. Solar Panel(s) generate electrical power when exposed to sunlight. Place a dark cover over
the panels when handling panels that have bare, un-insulated output wires. Accidental
shorting of panel terminals or wiring connected to the panels can result in spark causing
personal injury or a fire hazard.
19. It is important that the battery gets fully charged frequently ( at least once per week ).
Otherwise, the battery can become permanently damaged due to under charging. Partially
charged batteries can quickly sulfate internally which is an irreversible condition. It is good
practice to prevent a battery from being discharged below 50%. Deeper discharging
severely shortens battery life.
20. Keep the surface of Solar Panel(s) clean from dust / dirt / leaves / other debris. Clean with a
soft wet cloth ( to prevent scratching ). Do not walk on the panels.
21. Installation and wiring must comply with the local and National Electrical Codes and must
be done by a certified electrician.