Samlex Europe WSC-1230, Руководство пользователя, Страница: 19 / 31

19
8 Settings
ENG
8.2 Half power mode setting
When the switch S2 “HALF POWER” is pushed, the output power will reduce to half of the
chargers' amp rating and the “STATUS” LED will flash. The switch S2 is a kind of no memory
switch. That means "ON/OFF" status cannot be identified from the switch. To enter and exit
the "HALF POWER" mode by turns, please push the switch S2. The "HALF POWER" mode can
be told from flashing "STATUS" LED.
Due to the fan speed is adjusted according to the function of the load and the temperature
inside the charger, when "HALF POWER" mode is on, the fan speed will be slowed down and
become silent because of output current reducing to half the charger amp rating.
Note
1.
The half power mode can be set only when equalization function is NOT activated
or the charger is NOT in the power supply mode. (see Table 8-5 VOID Setting table
for pushing switch on front panel, Page. 20)
2. Please refer to section 9.4 on page 25 to understand the function of fan speed.
8.3 Equalization setting
When the switch S3 “E.Q.” is pushed, the function of equalization is activated and the “E.Q.”
LED will light RED. Whenever the function of equalization is activated, it only can be cancelled
by turning off the charger.
Note
The equalization function can be set only when the charger is NOT in the half power mode and NOT in
the power supply mode. (See Table 8-5 VOID Setting table for pushing switch on front panel, Page. 20)
Table 8-3 Switch Configure Power/Charger Mode
Table 8-4 Switch Configure Uo Phase Time Limit
Switch 4 Operation mode
OFF Battery charger
ON Power supply 13.2V/26.4V
Switch 5 Switch 6 Charging time
ON OFF 4 hours
OFF ON 6 hours
ON ON 8 hours
OFF OFF Unlimited