Sames Inocart VT, Инструкция по эксплуатации

Страница: 23 / 67

23 Member of Exel group
DRT7159
B - 2023/03
8. Maintenance
Note: This paragraph applies only to the maintenance of the Inocart cart.
For specific maintenance of the gun ( see DRT7132 ) and the Inobox control module ( see DRT7145 ).
Disconnect the power supply to the control module before connecting the gun. Before
disconnecting the gun, switch off, cut off the power supply to the control module (otherwise
a malfunction may occur).
8.1. Maintenance summary table
The soiling and wear of the different elements of the Inocart carriage caused by the passage of the powder depends
on the nature of the powder and the operating conditions.
Therefore, the periodicity of maintenance indicated in the procedures below is only indicative. The user will have to
create his own maintenance range as he uses the Sames equipment.
Procedure Detail Duration Frequency
Cleaning
A Cleaning of the cart 2 mn 8 Hours
B Powder pump / plunger tube cleaning 2 mn
8 Hours or at each
color change
Replacement
C
C1 Replacement of filter 30 mn -
C2 Replacement of vibrator 1 Hour -
C3 Replacement of elastic pads of the vibrating table 5 mn -
C4 Fast Clean replacement 5 mn -
C5 Replacement of the equipped porous washer 15 mn -