SaMASZ Z2-780, Руководство оператора, Страница: 29 / 44

Operator’s manual
Twin-rotor rotary rake
Z2-780; Z2-840
- 27 -
6. MOUNTING AND ADJUSTMENTS
6.1. Mounting and timing of the tines
The tines should be mounted as shown in
Fig. 29
.
Fig. 29. Mounting of rake’s tines
WARNING:
-
Use only tines recommended by manufacturer.
-
Before each operation check condition of tines and holders. Worn
or damaged tines should be replaced immediately.
-
Before changing the tine check direction of rotor turns
(
Fig. 29
).
6.2. Replacing connecting rods
In case of connecting rod damage, a simple replacement is possible by removing the damaged part.
Replace as follows:

Secure raking arm with support (
Fig. 13
),

Remove expansion pins (
K
) from arm mount,

Once pins are removed slide down arm mount from connecting rod,

Loosen four screws (
S
) that fix connecting rod to gearbox body,

Remove damaged connecting rod module,

Install new connecting rod,

Re-tighten the screws ( S ) with adequate torque,

Use support again when installing arm mount, securing it with expansion pins.
When replacing connecting rod it is not necessary to drain oil from the gear.
Fig. 30. Replacing connecting rod
K
S