SaMASZ SAMBA 160, Руководство оператора

Страница: 8 / 42

Instrukcja obsługi
Operator's manual
Lightweight, rear disc mowers
SAMBA
- 6 -
Tab. 3. Recommended PTO shaft
Mower
Power Length Momentum
Ref Clutch Manufacturer
HP mm / ft. in. Nm
SAMBA 160
SAMBA 200
SAMBA 240
SAMBA 280
SAMBA 320
35
660-900 /
2'2" - 2'11"
460 7G3N066CE007096MA
Right-hand
overrunning
BONDIOLI& PAVESI
NOTICE:
PTO shaft lubrication frequency must be respected. Points marked in Fig. 3 shall be
lubricated every 50 hours. PTO shaft should also be lubricated prior to and after longer
idle period.
Fig. 3. Shaft lubrication instructions. Shaft connection
PTO shafts of other brands with equivalent technical parameters may be used on the SaMASZ
permission.
4. SAFETY ADVICE AND WARNING
4.1. Safety rules and regulations
❑
Front axis of the tractor should be loaded by a minimum of 20% of tractor's overall weight to keep
the balance. If need be, use front wheel weights.
❑
Any operation with the hydraulic lift lever should be conducted from the operator's seat; DO NOT
move the lever from outside of the tractor.
In case of tractors equipped with EHR, controlling with hydraulic lift is conducted with a button
located outside the tractor's cabin. When operating, please be extremely careful.
❑
When switching from working to transport position the whole or at least one end (from tractor's
spline shaft side) of PTO shaft should be dismounted.
❑
Examine condition of guards and its mounting on regular basis. Operating without safety guards is
not permitted. Neither operation with damaged or raised guard is permitted (danger of stones, etc.
being thrown out). Damaged protective apron should be replaced with a new one.
❑
Start mowing only when the tractor's spline shaft reaches its nominal value of 540 rpm (for:
SAMBA 160, 200, 240, 280 ) or 1000 rpm (for: SAMBA 320 ).
PTO shaft end without clutch
–
To be mounted on the tractor side
PTO shaft end with right
overrunning clutch
–
To be
mounted from the mower side