Operator's manual
Trailed disc mowers
KDC
- 27 -
5.6.3.
Driving with mower over windrows when taking turns
Lift the cutterbar by means of hydraulic cylinder (
2
) (
Fig. 2a
,
Fig. 11
) and take a turn.
5.7.
Dismounting machine from the tractor
NOTE:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
deactivate cutterbar drive, ignition of tractor and removing the key of the tractor’s ignition
lock.,
reduce the pressure in the tractor's hydraulics,
Secure the machine against moving by placing wedges at wheels,
Fold out the support leg and protect with safety pin,
Disconnect the machine's hydraulics and electrics from the tractor,
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
delivered with the machine,
disengage the machine from hangers of the tractor's lower links by lifting the three-point
linkage,
carefully drive the tractor away.
5.8.
Storing machine
The mower should be stored on a hard, flat and level surface, under dry, roofed place to
protect it from atmospheric precipitation. It is forbidden to remove a support preventing tilting
single-axis equipment to the front or to the rear, if this is not required for work purposes.
6.
MOUNTING AND ADJUSTMENTS
6.1.
Mounting knives
Knives should be mounted in accordance with scheme provide in
Fig. 18, Fig. 20
. Cutting
knives should be mounted with principle, that the knife upon grass cutting should lift it up (cutting
edge should be lower).
Fig. 18.
Mounting cutting knives
NOTE:
Use only SaMASZ genuine cutting knives.
