Operating manual
Rear- side flail mowers on a pantograph
KBRP ; Kangu
- 11 -
Fig. 8.
Location of centre of gravity
Tab. 4.
Location of centre of gravity
Dimension
[mm]
Model
KBRP 160
KBRP 200
Kangu 140
Kangu 190
Kangu 220
A
1200
1530
1100
1470
1710
B
1000
950
800
850
900
C
390
420
350
370
380
4.5.
Working parts
❑
Before operating the mower check the condition of the flail blades.
❑
Worn or damaged flail blades should be immediately replaced.
WARNING!
When replacing working parts, always use protective gloves.
4.6.
The articulated telescopic shaft
❑
Before operating learn provisions found in bar manufacturer's manual placed on the bar.
❑
Use only articulated telescopic shafts recommended by the manufacturer of the mower.
❑
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO
shaft shall be repaired or replaced with new one.
❑
Before any operation make sure whether PTO rpm have proper rotational direction.
4.7.
Hydraulic assembly
❑
Elastic hydraulic hoses should be checked regularly and if any damage occurs or they expire,
replace with new ones. Replaced hoses must conform with the manufacturer's technical
requirements.
❑
Prior to performing service works at hydraulics the tractor's engine should be stopped and
ignition key taken out.
❑
It is not acceptable to adjust sweep valves on factory set distributors.
❑
Do not drain oil onto the ground, to the sewage system, into rivers or lakes. Only tight tanks
should be used for temporal storing of used oils.
❑
Used oils contain substances harmful for the natural environment and should be delivered to
a proper used oil treatment plant.