Salvis AFR1, Инструкция по эксплуатации

Страница: 7 / 8

7
Filling oil or melting fat
(effective capacity 5 - 7 litres)
- Close the drain tap (1).
- Remove cover and frying bas-
ket.
- Fill the container up to the MAX
mark with frying oil or place
frying fat on the heaters to melt
until the MAX mark is reached.
- Once the MIN mark has been
reached, the oil or fat must be
replenished.
Choice of frying temperature
- Turn the temperature control (4)
to the desired frying tempera-
ture. The green (2) and yellow
(3) indicator lamps light up.
- The yellow indicator lamp
remains lit up as long as the
heating is switched on. As soon
as it goes out, frying can be star-
ted.
Frying
- Place the food to be fried in the
basket, fill up to 1/3 to 1/2.
- Thoroughly shake off frozen
food before immersion.
- Place the basket in the tank.
- As soon as the food has the
desired brown colour, raise the
basket and hang in bracket (5)
to drip off.
Ready temperature
- To save energy, the temperature
control should be turned back to
100°C during long pauses in
operation.
Standby thermostat
- If the control thermostat does
not function correctly and the oil
overheats or if the oil level is too
low, the safety thermostat re-
sponds at 230°C and automati-
cally switches off the heating.
- The reset button is located on
the back of the heating connec-
tion box. The button can be
pressed in by means of a pin
and hence reset.
IT IS ESSENTIAL TO CHECK
THE OIL LEVEL.
- If the thermostat switches off
repeatedly, service must be re-
quested.
Maintenance
Filter the oil daily using the follo-
wing procedure:
- Remove the basket.
- Bring the heating element to the
drip position (7) by means of the
lever (6) and secure with the
retaining clip (8).
- Place the collecting container
with mounted oil filter under the
drain tap.
- The unit is equipped with a safe-
ty drain tap. To open it, pull the
lever upwards and then turn.
Drain the oil. It should still be at
a temperature of at least 60°C to
enable it to flow properly. Close
the drain tap immediately again.
- Empty the oil back into the deep
fat fryer tank. If necessary, add
more oil up to the MAX mark.
Cleaning
The deep fat fryer should be clea-
ned daily as follows:
- Carry out cleaning when the unit
is cold.
- Remove the basket, bring the
heating element to the drip posi-
tion (7) by means of the lever (6)
and secure with retaining clip
(8).
- Drain the frying oil completely.
- Clean the tank and heating ele-
ment with a mild cleaning agent
and rinse thoroughly. Clean the
basket in a dishwasher.
- Attention: Never clean the hea-
ting element with a steel wire
brush. Use household brushes
and ensure that the thermostat
sensors are not damaged.
- Do not spray the deep fat fryer
with a water jet.
- The outer jacket can be cleaned
with a commercial chromium
steel cleaner.
After sales service
Should your SALVIS electric range
ever require service, contact your
nearest SALVIS service centre. Be
sure the following check up has
been carried out before contacting
the service centre.
- Is unit plugged in?
- Mains switch.
- Mains fuses.
Note : When calling your service
centre, please provide model and
serial numbers shown on the ra-
ting plate located for AFR1 on the
rear side and for BFR1 on the in-
ner side of the control panel.