5
stubborn wrinkles.
1.
Fill water into the iron as described above to the maximum mark.
2.
Plug in the power base and switch “ON”.
3.
Adjust the temperature control dial to the “
MAX”
position.
4.
Set the iron onto the power base and allow the iron to heat for 2 minutes.
Note:
Please wait through 3 periods of the pilot light switching from “ON” to “OFF”.
5.
Make sure that the steam control button is in the “OFF” position and press the Burst of Steam button at
intervals of at-least 3 seconds.
6.
A powerful burst of steam will penetrate into the fabric assisting in removing wrinkles.
7.
After using for about 25 seconds, place the iron back onto the power base until the pilot light turns “OFF”.
The Burst of Steam function can then be repeated.
Note:
With conventional steam ironing, water may leak from the soleplate if a very low temperature has
been selected. If this happens, turn the temperature control dial to the advised position; steaming will
recommence as soon as the appropriate temperature has been reached.
DRY IRONING
The iron can be used as a dry iron even if there is water in the tank. Do not put water in the water tank when
the iron is to be used as a dry iron for a few hours at a time.
1.
Adjust the temperature control dial to reflect the temperature indicated by the garment care instructions
and make sure the steam control button is in the “OFF” position. Insert the power cord into the wall
socket.
2.
Set the iron onto the power base and allow the iron to heat for 2 minutes.
Note:
Please wait through 3 periods of the pilot light switching from “ON” to “OFF”.
3.
Remove the iron from the base and begin using.
5.
When the iron is no longer hot enough, return it to the power base for re-charging. Continue to do this
throughout the ironing process.
6.
After ironing, please turn the Temperature Control Dial to the “MIN” position. Pull the plug out, stand
the iron upright, and wait until the soleplate has cooled down completely before packing away for
storage.
SPRAY FUNCTION
This function can be used any time and is useful for use on heavily creased clothes and thicker fabrics. It is not
dependent on the temperature of the iron.
1.
Fill water into the iron up to the “MAX” level of water tank.
2.
Aim the spray nozzle at the garment.
3.
Press the Spray Button.
VERTICAL STEAM IRONING
1.
Hang the article to be steamed on a clothes hanger.
