OWNER’S MANUAL V.102021 ENGLISH
M-9530 ELLIPTICAL KOR
This manual can be downloaded on
www.salter.es
“
HARDWARE IDENTIFICATION CHART
”
Unpack the box in a clear area. Use the List of Hardware below to check the contents of the hardware kit. This
chart is provided to help identify the hardware used in the assembly process. Place the washers, the end of bolts,
or screws on the circles to check for the correct diameter. Use the ruler to check the length of the bolts and screws.
NOTICE:
The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw. Flat head bolts
and screws are measured from the top of the head to the end of the bolt or
screw.
After unpacking the unit,
you will notice that the package includes 2 bags of hardware (HARDWARE KIT A, B
and HARDWARE KIT C)
.
Assemb
ly’s
Step 1, 3
: Using HARDWARE KIT
A
Assembly’s
Step 4, 5, 6:
Using
HARDWARE KIT
B
Assembly’s
Step 7, 8, 9, 11, 12:
Using
HARDWARE KIT
C
Note:
a. Please review below to know the content of each hardware kit (A, B and C).
b. Some small parts may have been pre-attached for shipping. If a part is not in the hardware bag, check to see if
it has been pre-assembled.
HARDWARE KIT
A
Part No. and Description
Q’TY
100 Lock Washer (M8)
4
104 Washer (8x38x2.0t)
4
114 Nylon Nut (M10×p1.5)
2
139 Bolt (M8×p1.25×60mm)
4
142 Bolt (M10×p1.5×20mm)
2
