-10-
INSTALLATION
The installation must be carried out by a suitably qualified person, in
compliance with local electrical and building rules and specifications, and
the instructions outlined in this manual.
Installing the ceramic hob
Ensure that the appliance is installed in a suitable position, in consideration to adjacent
walls, cupboards and protection for combustible materials in accordance with local rules.
A suitable disconnection switch is to be incorporated in the permanent wiring. The switch is
to be of approved type and positioned in accordance with local wiring and electrical rules
and specifications. The switch must have 3 mm air gap contact separation in all poles, in
the active (phase) conductor of the fixed wiring.
The kitchen area should be dry and aired and equipped with efficient ventilation. When
installing the ceramic hob, easy access to all control elements should be ensured.
This is a Y-type design built-in ceramic, which means that its back wall and one side wall can
be placed next to a high piece of furniture or a wall. Coating or veneer used on fitted furniture
must be applied with a heat-resistant adhesive (100
℃
). This prevents surface deformation or
detachment the coating.
Hoods should be installed according to the manufacturer’s instructions.
IMPORTANT: You must observe the ventilation requirements and install accordingly.
IMPORTANT: There are ventilation holes around the outside of the hob. YOU MUST
ensure that these holes are not blocked by the work top, when you put the hob into
position (see figure).
IMPORTANT: Do not use a silicone sealant to seal the appliance against the aperture. This will
make it difficult to remove the hob from the aperture in future, particularly if it needs to be
serviced.