Salamander CT FORCE series, Инструкция по установке и гарантийный талон

Страница: 3 / 17

2 3
Pre-installation Checklist
(continued)
Don’ts

Never fit the pump to the cold water mains

Never fit the pump to shared incoming mains supplies to a block of flats

Never use a shared water supply

Never put a non-return valve (NRV), restrictive ballofix or an air vent on supply
pipe work to the pump

The hot water supply must not exceed temperature stated in the installation guide

Never use mechanical tools to tighten plastic coupler nuts as this may cause damage
and invalidate your warranty

Never use jointing compounds, Boss White, Hemp or steel wool

Solder fluxes must not come into contact with the pump or AV couplers

Never pump directly to or from any pump such as secondary return pump

Never fit pump to a Fortic, Primatic cylinder or Andrews type water heater.

If considering fitting pump to a Horizontal (torpedo) water cylinder then please
contact PumpWise on 0191 516 2002

Never fit the pump to a secondary tapping without a dip tube into the hot water cylinder
Pre-installation Checklist
Our pre-installation guidelines are detailed on the following pages, but some of the key
“do’s and don’ts” are highlighted below:
Do’s

Locate the pump next to the hot water cylinder within 5m of measured pipe. 2m MAX of
15mm pipework on inlet connections may be used.

Allow 100mm on all sides for ventilation

Ensure pump is protected from frost

If servicing two or more bathrooms, cold water supply to the cylinder
must be in 28mm pipework

Ensure adequate cold water storage (227 litres (50 gal) per bathroom,
364 litres (80 gal) for one bathroom and one en-suite)

Cold water supplies to the pump must be taken from the opposite side of
the cold water storage cistern to the cold water mains inlet

Multiple cold water storage cisterns must be linked in accordance with current
plumbing regulations and the bottom of the cisterns must be at the same level

Hot water supply to the pump must be via a Salamander approved method.

AV couplers must only be finger tight plus one quarter turn

The maximum static head should be 10m (equivalent to 1.0bar pressure)

We recommend the pump is activated for at least 5 minutes every 4 weeks
to ensure pump does not seize.

Ensure that installation complies with IET wiring regulations.

All AV hoses should be fitted straight with no twists or bends.

Ensure suitable means of isolation for maintenance

Bathroom Zones: Salamander products covered in these notes cannot be installed
in Zone 0 or Zone 1. They can however be installed in areas that are accessible with
a tool. (see Step 1 Pump Location for further information (Fig 5))