2. OPERATION
4) Turning the key to the START position makes the
engine start. Release the key the moment the engine
has started. The key will automatically return to the ON
position.
A
CAUTION ________________________________________________________
•
Do not allow the starter key to stay in the START position for more than 15
seconds.
•
If the engine does not start, allow an interval before trying again.
•
Check that the warning lamps on the monitor display go off immediately after the
engine is started. If any of these warning lamps becomes bright while the engine
is running, shut down the machine, determine the cause and rectify the fault.
2.3.3 After starting the engine
Try not to move to operation immediately after starting but observe the following:
__
IMPORTANT _____________________________________________________
Avoid increasing the engine speed abruptly before warming-up run is completed.
CD
,
Run the engine at around 1,200 rpm for about 5 minutes to warm it up. Warming-up run
allows the lubricating oil to reach the vital parts of the engine and hydraulic system, while
gradually bringing up the engine oil and hydraulic oil to the working temperature.
©After the warm-up operation, check that:
•
Temperature gauge .......................... Pointer falls near the center zone.
•
Fuel gauge ........................................ Pointer falls between the E and F marks
•
Charge lamp ..................................... Has gone off.
•
Engine oil pressure warning lamp .... Has gone off.
()Check for the color of exhaust gas, listen for unusual sounds and vibration., If abnormal,
determine the cause and correct the problem.
-
32 -
