SAJ Sununo-TL Series, Руководство пользователя

Страница: 15 / 31

User Manual
23
User Manual
24
Assembly Instructions:
1. Strip the cable with the length 0.276 inches (9/32
″
) - (7mm) and please be
careful NOT to nick conductors.
Figure 6.2
Integrated RCD and RCM
Current Protective Device) and RCM (Residual Current Operated Monitor).
The current sensor will detect the volume of the leakage current and compare it
with the pre-set value. If the leakage current is above the permitted range, the
RCD will disconnect the inverter from the AC load.
The SAJ grid-tie solar inverter will probably cause a DC current in the external
protective earthing conductor. Where a residual current-operated protective
(RCD) or monitoring (RCM) device is used for protection in a case of direct or
indirect contact, only an RCD or RCM of Type B is allowed on the supply side
of this product. Provided an AC current or pulse current is caused in the
external protective earthing conductor, an RCD or RCM of Type AC or Type A
as alternative can be permitted putting into use.
·
·
Never
DANGER to life due to potential fire or electricity
shock.
connect or disconnect the connectors under
load.
DANGER
Cable
0.276 inches(9/32
″
)-(7mm)
Figure 6.3
Figure 6.4
Figure 6.5
The SAJ grid - tie solar inverter is equipped with integrated RCD (Residual
2. Screw off and separate each component of AC connector as follows.
3. Pass the cable through each component from right to the left as follows.
Tighten the screws with 3.0N
·
m torque.
4. Use a screw driver and loose the three screws at the side of the straight plug.
Then insert the stripped N, L and PE cable accordingly to the corresponding
position and fully tighten the screws.
Connect L, N and protective conductor ( ) to the AC terminal in
accordance with the label.