Saito FA-170R3-D, Инструкция по эксплуатации

Страница: 7 / 27

2. Common Plug Activated
a. Solder the single lead from
the glow plug connectors to
one post of the female jack.
b. Attach the ground lead to the
remaining post on the female
jack.
To Glow Plug Connectors
c. Attach a male connector to
the positive and negative ter-
minals of your 1.5V starting
battery.
Refer to Fig. 2
3. Multi-Cylinder Glow Driver
There are many fine glow driver
units available on the market
today. Please follow the instruc-
tions included with the glow dri-
ver you’ve selected.
NOTE: The use of an on-board
glow system is highly recom-
mended. This will guarantee a
smooth, reliable idle. If an
on-board glow system will NOT
be utilized, replacement of the
standard McCoy glow plugs with
a ”hotter” plug, such as the
McCoy #3 heli plug (HAN3020),
K&B 4 cycle plug or equivalent is
suggested.
•
Glow Plug Wrench — Used to
remove and tighten glow plugs.
•
Manual or Electric Starter —
For manual starts, a ”chicken
stick” is highly recommended.
NEVER use your fingers to start
any model engine as doing so
invites injury. There are a variety
of electric starters on the market.
The Hangar 9 12V heavy-duty
Super Starter (HAN110) works
perfectly on all Saito multi-cylin-
der engines.
5
S
UPPORT
E
QUIPMENT
Saito manual doc 11/12/01 2:11 PM Page 5