Sailor RT5022, Руководство по эксплуатации

Страница: 27 / 60

23
Detail
5.2.2.2 Display Test
The information/message display is an LCD screen. A test of all pixels in the screen is
executed in menu 6.2. Triangles are displayed on the screen.
5.2.2.3 LED Test
You can verify that all light indicators including the channel display can be lit. Running the
LED test (6.3) will turn on all indicators for 2 seconds, whereafter these will return to their
previous state.
5.2.2.4 Alarm and Audio Test
Entering this test item (6.4) will route the distress and urgency alarm sound to all speakers
where this alarm is to be heard.
5.2.3 GPS
Sympton: Position requested.
If your radio is connected to a GPS and you receive a request on the screen to enter position
and time, there it is possibility that the GPS unit is either turned off, broken or disconnected.
The connection to the GPS is connected on the rear side of the radio (see Figure xx). Please
check physical connection.
Until GPS signal has been restored you must update the position manually as requested by
VHF.
— FIGUR til check af GPS/Option connector —
5.2.4 Accessory Connection
Symptom: Some or all of the remote units do not work
First turn off and on your VHF. Turn all remote units on if possible. Check status of the units
by going into the Accessories menu 4.6.2. In this menu you can read the status of any
connected device. If the status is “not found” for a particular device, it cannot be recognized
by your VHF.
The communication to the remote units is going via a serial multidrop bus connection on the
rear side of the radio (see Figure xx). Please check physical connection.
— FIGUR til check af SPARC connector —
0505