Sagrad DOC # 906-0001
Packing List
1. One SG901-1023 8 Channel Transmitter
2. One 9V DC Power Supply
3. One Antenna
4. Two Rack Mounted Brackets
5. One User / Installation manual
User Section
This product needs no adjustments. Follow the installation instructions and you are ready to
operate the unit.
Below is a list of frequencies that are being used on each channel:
Channel 1 = 72.1 MHz
Channel 2 = 72.5 MHz
Channel 3 = 72.9 MHz
Channel 4 = 75.3 MHz
Channel 5 = 72.3 MHz
Channel 6 = 72.7 MHz
Channel 7 = 74.7 MHz
Channel 8 = 75.5 MHz
The following describes the front panel LED operation (see equipment front and back
picture for LED display):
1. All LEDS blink at power on to help insure all lights are operational.
2. With no audio input detected (or the input is too low) only the first green LED blinks
once per second.
3. With Normal input the LEDS blink with the input level to show activity.
4. The Red LED comes on for 0.5 seconds when the input exceeds the limiter which
indicates the input volume should be reduced for better fidelity.
5. The power LED comes on when power is applied.
6. The Fuse LED lights when the input has been over voltage (wrong power supply). If
this occurs the unit will need to be repair by a trained service technician.
7. If the unit is operating in an over temperature condition one channel at a time will be
turned off until the over temperature condition is cleared. For each channel that is
turned off the red LED for that channel will be turned on constant.
This unit has automatic volume adjustment, For custom volume adjustments please contact
the factory or authorized service provider
