Sagrad DOC # 906-0001
EQUIPMENT CABINET INSTALLATION
The Sagrad equipment box contains the transmitters, antenna, power supply, rack
mounting hardware and wall mounting hardware.
Find a space that the cabinet will fit in/on near the A/V equipment that will be connected
to the transmitters.
The cabinet is 17 1/4” wide x 3 1/2” high x 10” deep.
CABINET MOUNT INSTALLATION
Step #1: Install rack mounted brackets on the two sides of the transmitter box
with the screws provided.
Step #2: Install the transmitter box into the communication rack and fasten
down with proper size screws (screws not provided) that fit your
communication rack.
CABLE INSTALLATION
There are up to ten (10) cables that need to be connected into the equipment in the
cabinet.
Step #1. Connect the audio input of the transmitters at the back of the
transmitter to the audio source selected using an RCA cables. Note
that the RCA cable are already labeled with the transmitter to be
used (Transmitter 1 – 8)
Step #2. Connect the supplied (9VDC converter) AC power cord to a
grounded AC outlet.
Step #3. Connect supplied Antenna to transmitter box.
CONNECTING AUDIO SOURCES TO TRANSMITTERS
Step #1: Connect one end of the 6’ RCA labeled audio cable provided to the
left/mono audio output” connection located on the back of the
DirecTV receiver.
Step #2: The other end of the 6’ RCA audio cable should be connected to
the “audio input” connection on the rear of the product.
