Sagola DRY TECH DT 3, Инструкция по эксплуатации

Страница: 20 / 30

00:00
100
050
ENGLISH
7.2. Automatic Mode
- Properly assemble the curing system according to the assembly instructions.
- Switch on the power supply. The display will
go through the start-up procedure and
automatically default to Automatic Mode. The
system is ready to use when the parameters
appears on the display screen as follows:
- Move the cassette forward or backward from the paint surface to adjust to the best distance for
curing. The distance data will be detected and shown on the display screen automatically. The
curing distance between the cassette and paint surface should be set according to the paint material
and weather conditions (air humidity).
Usually, keeping a distance of about 35-45 cm. from the paint surface
is recommended.
In order for the distance sensor to display the information correctly on the display, it
must be completely parallel to the piece to be dried, otherwise anomalies may occur
in the information to be displayed.
The sensor emits ultrasounds and bounces off the part to dry, returning to the sensor, and it only
works correctly when it is well positioned.
- The AUTO mode corresponds to a 3-step drying process. (Specially designed for the curing of
varnishes).
- Step 1 , Preheating. Corresponding to step 1 of the interface.
- Step 2 , Cured. Corresponding to step 2 of the interface.
- Step 3 , Cooling. It is done with the power and time parameters of step 2 of the interface
in PULSE mode.
- Press the button “Auto” to start automatic curing mode. Once the automatic mode is selected,
you can move through the interface by pressing the routine button.
Time adjustment
Distance adjustment
Power adjustment
AUTO
DT3/DT6 Version
PULSE TIME (min.)
POWER (%)
S
T
E
P
1
03:00 min.
70 %
ROUTINE TIME (min.)
POWER (%)
S
T
E
P
2
05:00 min.
65 %
PULSE TIME (min.)
POWER (%)
R
E
S
E
R
V
E
1
03:00 min.
60 %
ROUTINE TIME (min.)
POWER (%)
R
E
S
E
R
V
E
2
05:00 min.
55 %