Sagola 40000522, Инструкция по эксплуатации

Страница: 22 / 28

10. MAINTENANCE AND CLEANING
The maintenance of the machine must be performed
by qualified staff, according to the instructions in this
manual. Disconnect the pneumatic/electric supply
before performing any maintenance or repair opera-
tions.
The adhesive warning, legal obligation and prohibi-
tion labels and the installation plates on themachine
indicating the prohibitions and warnings are express-
ly indispensable. In the case of damage or non-rea-
dability, the labels must be replaced immediately.
It is absolutely forbidden to carry out operations with
the machine when not perfectly visible all the labels
or in the event of accidental were tampered with by
the location where they were previously placed.
10.1. EXTRAORDINARY MAINTENANCE
Extraordinary maintenance operations should only
be performed by specialized staff: contact the manu-
facturer for any extraordinary maintenance required.
Extraordinary maintenance usually regards the
breakage of machine components.
10.2. GENERAL CLEANING OF THE MACHINE
Every week give an overall clean to the machine,
using solvent and a brush or a spatula if especially
stubborn layers of paint have deposited.
Periodically check that the safety devices are functio-
nal and undamaged.
Any incrustations must be removed from the drains
and control valves regularly.
10.3. CLEANING OF THE SPRAY-JETS
Every 3 weeks, clean and drain off the spray-jets
placed inside the automatic washing tank then
proceed as follows:
- Unscrew all the washing nozzles from the relative
pipes.
- Fully immerse the nozzles soiled with paint in a
basin full of solvent and leave to soak for 1 hour.
- In the meantime run an empty wash cycle for
approx. 1 minute, this must be done without the
nozzles on the spider so as to clean the pipes of the
4 nozzles from any paint deposits.
- After the nozzles have soaked for an hour in the
solvent use the air gun to blow the washing nozzles
from the outside (fluid exit side) inwards.
- Screw the spraying nozzles into the related tubes.
10.4. CLEANING INSIDE THE AUTOMATIC WAS-
HING TANK
To make easy cleaning inside the automatic washing
tank, you can completely remove the washing
spray-jet device by unscrewing the central fixing nut
(No24).
10.5. CLEANING SUCTION FILTERS
Every 2 weeks, clean the suction filter present on the
suction pipe of the machine then proceed as follows:
- Unscrew the suction filter from the relative pipes.
- Fully immerse the filter (soiled with paint) in a basin
full of solvent and leave to soak for 1 hour.
- After soaking for 1 hour, use the air gun to blow the
filter.
- Screw the suction filters onto the relative pipes.
10.6. FILTER REPLACEMENT “PAINT STOP”
When the "Paitn Stop" filter does occur particularly
smeared with paint , replace it with a new filter
characteristics and similar size.
10.7. REPLACEMENT BRUSH HEAD
Every 4-6 months, verify the integrity of the brush
head and in case it occurs damaged and unusable,
unscrew the head and replace it with a new replace-
ment of the same type.
10.8. DRAIN FILTER REGULATOR
The filter assembly of the pressure regulator, filter
the presence of water at supply pneumatic. Emptying
short occurs automatically whenever you off the air
supply fast grafting machine.
It is possible still force the emptying by pressing the
metal pin in place on the bottom of the filter bowl the
pressure regulator.
Not groped to unscrew or remove the glass.
- 22 -