28
INFO
Hardware ver
Hardware version
Software ver
Software version
Working time
Total working time
Current time
Current working time
RDM UID
RDM
FACTORY RESET
Reset default settings – PWD =
UP+DOWN+UP+DOWN+ENTER
WIRELESS
RECEIVER
ON / OFF
Received mode activation
TRANSMITTER
ON / OFF
Transmitter mode activation
RELEASE
+/-
Wireless unlink
(*) How to use the upload function:
- select the projector where the CUSTOM PROGRAMS are stored
- select the projectors where copy all the CUSTOM PROGRAMS of the first projector and
connect all of them in chain, together with the first projector
with a DMX cable
- the projectors without programs must be set in SLAVE MODE
- in the first projector, set the UPLOAD function and insert the password UP-DOWN-UP-
DOWN-ENTER. In all the SLAVE projectors will be uploaded the CUSTOM PROGRAMS of the
master
- WARNING: programs already stored in the SLAVE projectors
will be deleted
6.2
– MASTER/SLAVE MODE WITH CABLE
In this way it is possible to connect different units in chain that work synchronously
1.
Connect all the units together from DMX OUT to DMX IN
2.
Define the first unit of the chain as Master, the other units must be set in SLAVE mode
3.
Put the master unit in Automatic mode or Static color mode. When the master unit will
start to work, all the other units (SLAVE) will start to work as the master
4.
IMPORTANT: during the working mode with cable, the wireless mode must be OFF
(RECEIVER=OFF / TRANSMITTER=OFF)
6.3
– MASTER/SLAVE MODE WITH WIRELESS
It is possible to use the Master / Slave chain also in wireless mode
1.
Select the units that will work as SLAVE
2.
In the submenu WIRELESS of these projectors, set RECEIVER=ON and TRANSMITTER=OFF
3.
In the submenu RELEASE press ENTER and after one of UP or DOWN buttons and wait until
the message “Clear connect – SUCCESS” disappears from the display. In this way the slave
unit is ready to receive the signal from the master.
4.
Under the submenu SLAVE set SLAVE and press ENTER
5.
Select the unit that will work as MASTER and select the Automatic or Static color modes
that it will run. This function will be run only in the MASTER unit
6.
Again in the MASTER unit enter under the submenu WIRELESS and set RECEIVER=OFF and
TRANSMITTER=ON. Again under the submenu TRANSMITTER=ON, press again ENTER, the
writing ON will be highlighted. Press again ENTER, the writing ON lose the highlighting and
MASTER unit starts to link the SLAVE units.
After 10 seconds approximately
, all the SLAVE
units will be automatically linked to the master and they starts to run the same program
of the master.
7.
In order to disconnect all the SLAVE units from the MASTER at the same time, go under
the submenu RELEASE of the MASTER, press ENTER and after press one of UP or DOWN
buttons and wait that the message “Clear connect – SUCCESS” disappears from the
display. In this way all the SLAVE units will be automatically unlinked from the MASTER.
