Proc Sheet 2 04
myZ-5
5HPRYHDQG3ODFH
7KH00,/&'
1/2
7RROV
- Phillips screwdriver
-
Tweezers.
-
Soldering iron
-
Plait to be unsolder
-
Plectrum
-
Gloves
3UHOLPLQDU\RSHUDWLRQ
1. Remove the battery (
Proc sheet 0 01
).
2. Remove the lower casing of mobile (
Proc sheet 1 01
).
3. Remove the equipped electronic board (
Proc Sheet 1 18
).
4. Remove the upper casing of mobile (
Proc sheet 1 13
).
5. Remove the lower casing of FLAP (
Proc sheet 1 26
).
6. Remove the FPC (
Proc Sheet 1 30
).
5HPRYDOSURFHGXUH
7KLVSURFHGXUHPXVWEHSHUIRUPHGE\DWHFKQLFLDQZLWKJORYHV
1. Unstuck the loudspeaker of its housing (1) (
(DFKORXGVSHDNHUXQVWXFNPXVWEHSXWRIIDQG
UHSODFHE\DQHZ
2. Remove the MMI Display with the plectrum (2).
3. Unsolder the loudspeaker on the equipped MMI Display and take care of the wiring sense (3).
3ODFHPHQWSURFHGXUH
1. Flux the place of the loudspeaker and solder on the equipped MMI Display, respecting the wiring sense
(3).
2. Place the new MMI Display in its housing (4).
3. Stick the loudspeaker in its housing.
)XUWKHURSHUDWLRQV
1. Place the FPC (
Proc Sheet 1 30
).
2. Place the lower casing of FLAP (
Proc sheet 1 26
).
3. Place the upper casing of mobile (
Proc sheet 1 13
).
4. Place the equipped electronic board (
Proc Sheet 1 18
).
5. Place the lower casing of mobile (
Proc sheet 1 01
).
6. Place the battery (
Proc sheet 0 01
).
Risk of the procedure:
•
Damage the MMI Display.
•
Oxide the MMI Display.
•
Damage the FPC.
•
Reverse the loudspeaker wiring.
Procedure
Symptom
Test
REF MTB DTS 9- Indice B - December 09 2005
Page 5-33