23
Care and Maintenance
Use a slightly damp cloth to wipe the base and handset as well as charging contacts, do not
use a dry cloth as this may cause electrostatic charges.
Problems
Refer to the table presented below in case of an operational malfunction:
Problems
Remedies
The base indicator light is not lit
Make sure that :
•
the power adapter is properly connected to a power socket.
•
the power connector is properly plugged into the base.
•
your fuse and circuit-breaker are in working order and that the power
socket is powered.
The handset display is blank
Make sure that the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
To increase the life of your batteries, you can perform this operation about every
two months.
If these precautionary measures do not resolve this issue, replacement
batteries are available through your reseller.
As time goes by, you may notice a slight decrease in battery performance. Use
your handset until the battery is fully discharged, and then charge it for at least
6 hours.
Note: as time goes by, you may notice a slight decrease in battery performance.
Use your battery until the battery is fully discharged, then charge it for at least 6
hours. Fully discharging the batteries at least once every two months will help
them to last as long as possible.
The handset does not ring
during an incoming call
Make sure that the telephone is properly connected and that you have a dial
tone.
Make sure that your telephone is not set to silent mode (refer to paragraph
Modifying the default handset melody volume, page 15).
No radio link between the
handset and base
The network indicator icon
flashes
Make sure the handset is registered by moving closer to the base, if it is
registered correctly, the handset screen should display its own handset number.
Otherwise, register the handset to the base (refer to paragraph Registering a
second handset to a base, page 21).
Programming not possible
You have already logged in two handsets. You must delete one handset first
(refer to paragraph De-registering a handset, page 22).
Radio Interference occur during programming, retry the programming, if
possible move closer near the D20T base station.
Interference during
communications
Out of range or close to other electrical appliances :
Check the handset is not emitting the out of range warning tone. If close to
other electrical device move away. You may need to reconsider the location of
your D20T Base if this problem persists.
Entries will not be accepted in
the DIRECTORY.
Directory is full :
Up to 25 names and numbers can be stored in the D20T Directory. Delete some
of the older entries to make more space for new one.
A
PPENDIX
LU 251619615_D20T_GB_SAGEM.book Page 23 Jeudi, 26. août 2004 4:54 16
