Cemented Carbide Scrapers
SPOTHEATER SH1000
•
IR PAINT REMOVER
For professionals and DIY.
Using the SpotHeater SH1000
Paint Removal
Turn on the SpotHeater and allow it to warm until IR elements are glowing orange. Hold
the SpotHeater parallel to the surface for about 20 - 60 seconds, or until you see the
paint begin to soften and bubble. Safely rest the SpotHeater on its side and remove
softened paint with a sharp scraper. Removal time can vary depending on the paint film,
the nature and thickness of the paint, and the ambient temperature and humidity on site.
While scraping, let the SpotHeater rest with the IR tube facing up and away from the
work surface so that excess heat is vented away and does not burn the substrate. When
removing paint from larger areas, you can develop a rhythm where you heat a new area
while you scraped the surface you just heated.
Other Uses
The SpotHeater can also be used for many projects such as curing and accelerated drying
of polyester laminates, plasters, paint for cars, general painting and other tasks where
curing is required. It can also be used for removing decals and stripes from cars, and can
be used for thawing ice plugs and frozen pipes. Always test for the appropriate distance
from the surface and exposure time for your project. Take special care to avoid damage
to the surface you wish to heat.
NOTE:
Do not forget to always switch the unit to “OFF” when it is not in use.
Overheat Protection
In rare cases, the temperature can exceed safety levels, which will trigger the automatic
shutoff protection.
CAUTION:
When the automatic overheat protection is triggered,
the light on the ON-OFF switch stays on, even if the device has stopped working.
Once cooled, the unit will automatically start functioning again. Turn the power
switch to “OFF” and wait until the SpotHeater has cooled.
ACCESSORIES:
Window Restoration
With the SpotHeater SH1000, you can easily remove
old paint and putty in the same operation. This method
is gentle on wood, but glass exposed to heat must be
protected with a heat shield. Position the SpotHeater with
one side shield set at the putty line so as to avoid the
glass. This method is gentle on wood and reduces the risk
of cracking the glass. The softened paint and putty can be
removed carefully with a sharp scraper. Use the optional
support bar accessory for hands-free operation.
Carbon Steel
Scrapers
