background image

Examine Your Warmer

Unpack warmer, remove all packing material and examine the unit for any damage such as dents, broken door latches,
etc. Notify Sage Products immediately if warmer is damaged. 

DO NOT

install or operate if warmer is damaged.

Remove Protective Plastic Film

If a plastic film has been wrapped around the warmer to protect the painted finish from scratching during shipping,
please remove this plastic film prior to using the warmer (however, not all warmers have plastic film wrapping)

.

Placement of Warmer

1. Warmer must be placed on a flat, stable surface. For proper operation, the warmer must have sufficient air 

flow. Allow 3 inches (7.62cm) of space on both sides and back of the warmer and 1 inch (2.54cm) of space on 
top of the warmer. 

(Placing 2 of the 14 ct. warmers side by side is acceptable)

a) 

DO NOT

block air vent. If it is blocked during operation, the warmer may overheat. 

If the warmer overheats, a thermal safety device will turn the unit off. The warmer will 
remain inoperable until it has cooled.

b) 

DO NOT

place warmer near a hot, damp surface such as a gas or electric range.

c)  Be certain that power cord on the warmer can reach the electrical outlet.
d)  Be certain electrical outlet is not blocked by the warmer. Power cord must be able to be unplugged 

without moving the warmer.

Grounding Instructions

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of an electric
shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounded
wire with a grounded plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING

: Improper use of the grounding plug can result in a risk of electric shock.

Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.

If it is necessary to use an extension cord, use only a three-slot receptacle that will accept the plug on the appliance.
The marked rating of the extension cord should be equal to or greater than the electrical rating of the appliance.

Wiring Requirements

1.

The warmer must be plugged into at least a 15-AMP, 115-VOLT, 

60-Hz GROUNDED OUTLET.

Where a standard two-prong outlet is encountered, it is the personal 
responsibility and obligation of the user to have it replaced with a 
properly grounded three-prong outlet 

(Figure 1).

INSTALLATION AND  GROUNDING  INSTRUCTIONS

Figure 1

Содержание Comfort 7944









Отзывы: