Quantum™ MT™ Installation Instructions
Pg. 3 of 8
Preparing the door and door frame (continued)
3. The mortise plate has an adjustable bevel. Align the mortise front plate with the bevel of the door
edge and tighten the two bevel adjustment screws at the top and bottom of the mortise case. Position
the mortise case in the door edge with the motor wire routed through the notch (see Fig. 1).
Note:
Use care to ensure that the wires do not get pinched or pulled as the mortise is inserted into
the pocket.
4. Attach the mortise front plate to the door using the two mortise screws (12 x 1-1/4 screws for wood
doors, 12-24 x 3/8 screws for metal doors). Be sure that the screws are fully tightened.
Important:
DO NOT leave the screws loose. The screws must be fully tightened before the trim is
installed. If you must leave the mortise loose to install the trim, the door preparation is incorrect.
5. Install the scalp plates with the 8-32 x 1/4 screws provided and test for proper mechanical latch
engagement into the strike plate.
Fig. 1
Mortise
Screws
Notch for routing
the motor wire
(inside only)
Inside Door
Surface
Mortise Front Plate
Motor
Wire
© SAFLOK™
INS_QTMCARDMT
2/16/2012
