2023 Copyright Safewaze
Safewaze Sliding Beam Anchors are equipped with replaceable jaws should the original set become overly worn or
damaged. Removal and installation is easy and only requires the removal of (2) T8H Torx Screws per jaw. Simply
remove the screws using a T8H Torx Security Screwdriver (Not Included) and detach the worn jaw. Slide the new jaw
into the clamp assembly and reinstall the (2) T8H Torx Screws per jaw. Tighten the T8H Torx Screws until firmly snug to
complete installation. Figure 12 illustrates jaw replacement for the 021-4068 and 021-4069, while Figure 13 illustrates the
021-4075.
17.0 JAW REPLACEMENT
9
FIGURE 12 - 021-4068 / 4069 JAW REPLACEMENT
FIGURE 13 - 021-4075 JAW REPLACEMENT
19.2 CLEANING
Remove the Safewaze anchor from use if subjected to fall arrest forces or inspection reveals an unsafe or defective
condition. If unsafe or defective condition is found, dispose of the anchor as recommended in section 21.0.
19.0 MAINTENANCE, CLEANING, & STORAGE
19.1 MAINTENANCE
Precautions should be taken in the design and installation of a PFAS in order to avoid hazards such as thermal, chemical,
or electrical hazards. Avoid moving machinery, sharp and/or abrasive edges, and any other hazard that could damage or
degrade components of the PFAS.
18.0 APPLICATION LIMITS
Anchor can be cleaned with water and mild soap if necessary. User should remove all dirt, possible corrosives, and
contaminants from the anchor prior to, and after each use. Never use any type of corrosive substance to clean the
anchor. Excess water should be blown out with compressed air. Hardware can be wiped off with a clean, dry cloth.
Part # 021-4071
Replacement Jaws for the
021-4068 / 021-4075
Part # 021-4074
Replacement Jaws for the
021-4069
