User Manual
V1.7 2021 Copyright SafeWaze
Page 18
Slide washer (a) onto tensioning assembly. Thread the tensioning nut (b) onto
tensioner until approximately 3 to 5 threads are exposed below the nut (See Figure 10
- Step 1). Pull up on Tension Assembly until washer (a) contacts bottom of spring.
Ensure excess cable slack is again removed from system and torque fist grips to
35 ft-lbs. (See Figure 10 - Step 2). Tighten tensioning nut (b) on tensioner until 1/2” of
tension indicator (d) is visible or cable is taut. Tighten locking nut (c) until snug to
tensioning nut (b). Cut excess slack off end of cable (e) (See Figure 10 - Step 3).
a
a
b
b
b
c
c
c
3-5 Threads Left
Exposed
FIGURE 10 - TENSION THE CABLE
Step 1
Step 2
Step 3
d
e
