User Manual
V1.7 2021 Copyright SafeWaze
Page 12
Step 1: Installation of Top Bracket
Prior to installation of the Top Bracket, a Qualified Person should determine that the
structure is capable of meeting the load requirements of the system. Ensure that the
Top Bracket is positioned to allow users safe access when connecting or disconnecting
from the system. As a general rule, the Top Bracket is centered on the climbing
structure to allow for ease of climbing. However, the bracket may be installed
towards the side of the structure if necessary (See Section 10).
Two User Capacity Top Bracket - Part# 019-12022 (Figure 5A):
Line up the
pre-drilled holes on the bracket with the top rung of the climbing structure. Slide the
upper rung clamp over the back of the rung and through the two pre-drilled holes in the
bracket. Thread nuts onto the rung clamps and torque to 20-25 ft. lbs. The Top Bracket
includes a pre-cut slot for adjustment to align the lower rung clamp with the lower rung.
Position the lower rung clamp on the lower rung using the pre-cut slot, install the nuts
onto the clamp, and torque to 20-25 ft. lbs.
Four User Capacity Top Bracket - Part# 019-12024 (Figure 5B):
Line up the
pre-drilled holes on the bracket with the top rung of the climbing structure. Slide the
upper rung clamp over the back of the rung and through the two pre-drilled holes in the
bracket. Thread nuts onto the rung clamps and torque to 20-25 ft. lbs. The Top
Bracket includes pre-cut slots for adjustment to align the middle and lower rung clamps
with their corresponding rungs. Position the middle and lower rung clamps on the
rungs,install the nuts onto the clamps, and torque to 20-25 ft. lbs.
Two User Capacity Top Bracket with 48” Extension - Part# 019-12023 (Figure 5C):
Line up the pre-drilled holes on the bracket with the top rung of the climbing structure.
Slide the upper rung clamp over the back of the rung and through the two pre-drilled
holes in the bracket. Thread nuts onto the rung clamps and torque to 20-25 ft. lbs. The
Top Bracket includes pre-cut slots for adjustment to align the middle and lower rung
clamps with their corresponding rungs. Position the middle and lower rung clamps on
the rungs,install the nuts onto the clamps, and torque to 20-25 ft. lbs.